View source for Engineering:A-004

{{Infobox spaceflight<!--technically not a spaceflight, but template seems best fit for this article-->
| name                  = A-004
| image                 = Little Joe II A-004.jpg
| image_caption         = Little Joe II A-004, White Sands, New Mexico
| insignia              = Apollo program.svg

| mission_type          = Abort test
| operator              = [[Organization:NASA|NASA]]
| mission_duration      = 6&nbsp;minutes, 50&nbsp;seconds
| distance_travelled    = {{convert|34.63|km|mi|sp=us}}
| suborbital_apogee     = {{convert|23.83|km|mi|sp=us}}

| spacecraft            = [[Engineering:Apollo (spacecraft)|Apollo]] CM-002
| manufacturer          = 
| launch_mass           = 
| landing_mass          =

| launch_date           = {{start-date|January 20, 1966, 15:17:01|timezone=yes}}&nbsp;UTC
| launch_rocket         = [[Engineering:Little Joe II|Little Joe II]]
| launch_site           = White Sands LC-36

| landing_date          = {{end-date|January 20, 1966, 15:23:51|timezone=yes}}&nbsp;UTC
| landing_site          =

| previous_mission      = [[Engineering:Pad Abort Test 2|Pad Abort Test 2]]
| next_mission          = 
| programme             = [[Astronomy:Apollo program|Project Apollo]]<br/><small>Abort Tests</small>
}}

'''A-004''' was the sixth and final test of the [[Astronomy:Apollo program|Apollo]] launch escape vehicle and the first flight of a Block I production-type Apollo Command/Service Module.

==Objectives==

'''Mission A-004''' was uncrewed and was conducted to demonstrate that 
# The launch escape vehicle would satisfactorily orient and stabilize itself in the proper attitude after being subjected to a high rate of tumbling during the powered phase of an abort
# The escape vehicle would maintain its structural integrity under test conditions in which the command module structure was loaded to the design limit.

The launch vehicle was the fifth and final [[Engineering:Little Joe II|Little Joe II]] flown. The propulsion system consisted of four Algol and five Recruit rocket motors. The attitude control system was similar to the one used on mission A-003 except that the reaction control system was deleted and the vehicle was provided with the capability of responding to a radio-transmitted pitch up command. The 
pitch up maneuver was required to help initiate tumbling of the launch vehicle. The spacecraft for this mission consisted of a modified Block I command and service module (Block I production model 002), and a modified Block I [[Astronomy:Launch escape system|launch escape system]] (airframe 002). The center of gravity and thrust vector were changed to assure that power-on tumbling would be attained after abort initiation. The Earth landing system was essentially the same as that used during Pad Abort Test 2.

==Flight==

The vehicle was launched on January 20, 1966, at 8:17:01&nbsp;a.m. MST (15:17:01 UTC) after several postponements due to technical difficulties and adverse weather conditions. The pitch up maneuver was commanded from the ground when telemetry showed that the desired altitude and velocity conditions had been reached. The planned abort was automatically initiated 2.9 seconds later. The launch escape vehicle tumbled immediately after abort initiation. Pitch and yaw rates reached peak values of 160 degrees per second, and roll rates reached a peak of minus 70 degrees per second. The launch escape system canard surfaces deployed at the proper time and stabilized the command module with the aft heat shield forward after the escape vehicle had tumbled about four times. Tower jettison and operation of the Earth landing systems were normal, and the command module landed about 113,620 feet (34.6&nbsp;km) from the launch pad after having reached a maximum altitude of 78,180 feet (23.8&nbsp;km) above mean sea level.

All systems performed satisfactorily, and the dynamic loads and structural response values were within the design limits and predicted values. Although a structural loading value of primary interest was not achieved (local differential pressure between the interior and exterior of the command module wall), all test objectives were satisfied.

== Boilerplate location==
The boilerplate spacecraft is currently on display at the Cradle of Aviation Museum, Garden City, New York.<ref>{{cite web |url=http://www.cradleofaviation.org/history/permanent_exhibits/exploring_space/rockwell_command_module_002.html |title=Rockwell Command Module 002 at the Cradle of Aviation Museum |access-date=2013-08-10 |url-status=dead |archive-url=https://web.archive.org/web/20140106070723/http://www.cradleofaviation.org/history/permanent_exhibits/exploring_space/rockwell_command_module_002.html |archive-date=2014-01-06 }}</ref>

==References==
<references />

==External links==
*[http://www.hq.nasa.gov/office/pao/History/SP-4009/cover.htm The Apollo Spacecraft: A Chronology] {{Webarchive|url=https://web.archive.org/web/20171209084600/http://www.hq.nasa.gov/office/pao/History/SP-4009/cover.htm |date=December 9, 2017 }}
*[https://history.nasa.gov/apsr/apsr.htm Apollo Program Summary Report]
*[https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19790076764_1979076764.pdf Little Joe II Qualification Test Flight Report - September 1963 (PDF)]
*[https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19780070078_1978070078.pdf Little Joe II Progress Report - December 1964 (PDF)]
*[https://ntrs.nasa.gov/archive/nasa/casi.ntrs.nasa.gov/19740073286_1974073286.pdf Postlaunch Report for Little Joe II Mission A-004 - April 1966 (PDF)]

{{Apollo program| before=A-105| after=[[Engineering:AS-201|AS-201]]}}

{{Include-NASA}}


[[Category:Apollo program]]
[[Category:Test spaceflights]]

{{Sourceattribution|A-004}}