Earth:Bedout

From HandWiki
Revision as of 10:43, 5 February 2024 by Len Stevenson (talk | contribs) (link)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Short description: Geological and geophysical feature in Western Australia
Bedout
Lua error in Module:Location_map at line 522: Unable to find the specified location map definition: "Module:Location map/data/Western Australia" does not exist.
Impact crater/structure
ConfidencePossible
Diameter30 km (19 mi)
Age250.1 ± 4.5 Ma
Permian-Triassic boundary
ExposedNo
DrilledYes
Location
LocationCanning Basin
Coordinates [ ⚑ ] : 18°S 119°E / 18°S 119°E / -18; 119
Country Australia
StateIndian Ocean

Bedout /bɪˈd/, or more specifically the Bedout High, is a geological and geophysical feature centered about 250 km (160 miles) off the northwestern coast of Australia in the Canning and overlying Roebuck basins. Although not obvious from sea floor topography, it is a roughly circular area about 30 km (20 miles) in diameter where older rocks have been uplifted as much as 4 km (2.5 miles) towards the surface and may mark the centre of a very large buried impact crater up to 250 km (160 miles) in diameter.[1] The Bedout High was penetrated by two petroleum exploration wells (Bedout-1, Lagrange-1) in the 1970s and 1980s. It is named after nearby Bedout Island.

Impact hypothesis

In 1996 Australian geologist John Gorter first suggested that the Bedout High might mark the centre of a very large buried impact crater up to 250 km (160 miles) in diameter, based mainly on its internal geological structure as revealed on a single seismic survey line, and suggested that it may be of near end Permian age, based on the reported age of volcanic rocks in Lagrange-1.[1][2] The impact hypothesis was developed further by Luanne Becker (University of California) and coworkers who claimed to have confirmed that the supposed volcanic rocks in the petroleum wells are actually impact melt breccia showing evidence of shock metamorphism, and re-dated these rocks at 250.1 ± 4.5 Ma.[3] The new age is essentially coincident with the PermianTriassic boundary and associated extinction event, and Becker speculates that there is a likely connection. It was subsequently reported, based on very limited preliminary data, that the impact hypothesis is further supported by chromium isotope evidence for the presence of extraterrestrial material.[4]

Rebuttals to the impact hypothesis

The Bedout impact hypothesis has not been widely supported by impact cratering specialists. Specific counter claims include:

  1. The alleged impact melt breccia actually has the characteristics of a volcanic basalt, in part altered by contact with sea water and metamorphism due to its deep burial, and the evidence for shock metamorphism is likely mistaken.[5][6]
  2. A crater of the purported size would have produced a widespread layer of ejecta, but no such eject is evident at the nearest Permian-Triassic boundary sites in Australia.[7]
  3. The presented evidence for impact fails to meet established standards, and the dating methodology is flawed.[8]
  4. A detailed re-evaluation of the geophysical data indicates that the evidence is not consistent with the expected properties of a giant impact crater, but rather the Bedout High was likely the result of episodes of continental rifting.[9]

See also

References

  1. 1.0 1.1 Gorter J.D. 1996. Speculation on the origin of the Bedout high - a large, circular structure of pre-Mesozoic age in the offshore Canning Basin, Western Australia. PESA News, October/November 1996, p. 32-34.
  2. Gorter J.D. 1998. The petroleum potential of Australian Phanerozoic impact structures. The APPEA Journal 38, 159-187.
  3. Becker L., Poreda R.J., Basu A.R., Pope K.O., Harrison T.M., Nicholson C. & Iasky R. 2004. Bedout: A possible end-Permian impact crater offshore of northwestern Australia. Science 304, 1469-1476. Abstract
  4. Becker L., Shukolyukov A., Macassic C., Lugmair G. & Poreda R. 2006. Extraterrestrial Chromium at the Graphite Peak P/Tr boundary and in the Bedout Impact Melt Breccia. Lunar and Planetary Science XXXVII (2006), abstract # 2321.PDF
  5. Glikson A. 2004. Comment on ‘‘Bedout: A possible end-Permian impact crater offshore of northwestern Australia’’. Science 306, 613b.PDF
  6. Glikson A. 2004. Bedout basement rise, offshore northwestern Australia: evidence of an unshocked mafic volcanic hyaloclastite volcanic breccia. Eos Trans. AGU, 85(47), Fall Meet. Suppl., Abstract B33C-0269. Abstract
  7. Wignall P., Thomas B., Willink R., Watling J., Becker L., Poreda R.J. & Pope K.O. 2004. Is Bedout an impact crater? Take 1. Science 306, 609-610.
  8. Renne P.R., Melosh H.J., Farley K.A., Reimold W.U., Koeberl C., Rampino M.R., Kelley S.P., Ivanov B.A., Becker L., Poreda R.J., Basu A.R., Pope K.O., Harrison T.M., Nicholson C. & Iasky R. 2004. Is Bedout an impact crater? Take 2. Science 306, 610-612.
  9. Müller R.D., Goncharov A. & Kristi A. 2005. Geophysical evaluation of the enigmatic Bedout basement high, offshore northwest Australia. Earth and Planetary Science Letters 237, 265-284.

External links