Engineering:High-Capacity Artillery Projectile (HICAP)
High-Capacity Artillery Projectile (HICAP), a 155-mm two-piece artillery shell, was developed by the U.S. Army from 1992-1996.[1] HICAP was part of a major effort by the U.S. Army – called the Composite Artillery Projectile Program – to develop lightweight ammunition for 155-mm M199 gun tubes.[2] The program sought to replace 155-mm steel shells with a two-piece design permitting the weight savings to be allocated to increased payload or longer range.[3] The project was collaborative effort between the U.S. Army Research Laboratory (ARL) in Aberdeen, MD and the U.S. Army Armament Research, Development, and Engineering Center (ARDEC) in Picatinny Arsenal, NJ.[2] Five HICAP projectiles were successfully tested at the Yuma Proving Ground, AZ in June 1996.[1]
Background
The Army’s early 155-mm artillery had steel bodies and weighed 100 lbs. 65% percent of the weight of the shell was in the steel body. This original design, while durable enough to withstand inertial loads during firing, was limited in the amount of munitions that could be carried within the shell.[1]
During the Composite Artillery Projectile Program, the Army sought to enhance the payload of 155mm shells while reducing the ammunition’s bulk. A mass-efficient projectile, also called High-Capacity Artillery Projectile, was developed through the use of composite materials, which offered both weight reduction and material strength to withstand severe firing conditions.[1]
While HICAP shell was a lighter ammunition than its predecessor, it lacked the outer shell mass for adequate stability during flight. A deployable fin assembly was designed from 1992-1994 at ARL, which included six-blade fins at the base of the shell, allowing the projectile to maintain forward center of gravity after firing.[1]
Description
The HICAP was a two-piece projectile using a six-blade fin configuration. The fins were designed to be stowed in the barrel and deployed from the shell at muzzle exit. The round consisted of two parts, each carrying a full single load of cargo. A quick-connect joint was designed at the center of the round to allow transport of the two pieces. When assembled, HICAP was 72-in long with ½-in wall thickness and weighed 74 lbs.[1]
References
- ↑ 1.0 1.1 1.2 1.3 1.4 1.5 Composi, Amer Society (1999-10-25) (in en). American Society of Composites, Fourteenth International Conference Proceedings. CRC Press. ISBN 9781566767910. https://books.google.com/books?id=78G-HIuvwAMC&q=High-Capacity+Artillery+Projectile&pg=PA227.
- ↑ 2.0 2.1 "High-Capacity Artillery Projectile (HICAP) Fin Characteristics". http://apps.dtic.mil/dtic/tr/fulltext/u2/a289575.pdf.
- ↑ "Founding of ARL | U.S. Army Research Laboratory" (in en). https://www.arl.army.mil/www/default.cfm?page=488.
 |
