Physics:Types of snow

From HandWiki
Hoar frost that grows on the snow surface due to water vapor moving up through the snow on cold, clear nights

Types of snow can be designated by the shape of its flakes, description of how it is falling, and by how it collects on the ground. A blizzard and snow storm indicate heavy snowfalls over a large area, snow squalls give heavy snowfalls over narrow bands, while flurries are used for the lightest snowfall. Types which fall in the form of a ball, rather than a flake, are known as graupel, with sleet and snow grains as types of graupel. Once on the ground, snow can be categorized as powdery when fluffy, granular when it begins the cycle of melting and refreezing, and crud or eventually ice once it packs down into a dense drift after multiple melting and refreezing cycles. When powdering, snow drifts with the wind or ground blizzard, sometimes to the depth of several metres. After attaching to hillsides, blown snow can evolve into a snow slab, which is an avalanche hazard on steep slopes.

While falling

A snow flurry viewed from Buffalo City Hall

Snowfall's intensity is determined by visibility. When the visibility is over 1 kilometre (0.62 mi), snow is determined to be light. Moderate snow describes snowfall with visibility restrictions between .5 kilometres (0.31 mi) and 1 kilometre (0.62 mi). Heavy snowfall describes conditions when visibility is restricted below .5 kilometres (0.31 mi).[1]

Other terms for falling snow:

A thunderstorm which produces snow as the primary form of precipitation.
A long-lasting snow storm with intense snowfall and usually high winds. Particularly severe storms can create whiteout conditions where visibility is severely reduced.
Snow storm
Usually, a long storm of relatively heavy snow, similar to a blizzard but without the wind requirement.
A brief, very intense snowstorm.
Snow flurry
Describes a period of light snow with occasional moderate snowfall but usually little accumulation.
Lake-effect snow
Produced when cold winds move across long expanses of warmer lake water, picking up water vapour which freezes and is deposited inland.
In Canada , United Kingdom , Australia , New Zealand, and some parts of the US: rain mixed with snow. In much of the US sleet means ice pellets formed when snowflakes pass through a layer of warm air, partially or completely thaw, then refreeze upon passing through sufficiently cold air during further descent.
Diamond dust
Describes a fine mist of tiny frozen ice crystals.


A column type snowflake.
A class of snowflakes that is shaped like a six sided column.
A class of snowflakes that has 6 points, making it somewhat star shaped. The classic snowflake shape.
Precipitation formed when freezing fog condenses on a snowflake, forming a ball of rime ice. Also known as snow pellets and soft hail.
A class of snowflakes that are acicular in shape (their length is much longer than their diameter, like a needle)
Rimed snow
Snowflakes that are partially or completely coated in tiny frozen water droplets called rime. Rime forms on a snowflake when it passes through a super-cooled cloud.
Snow on trees in DuBois, Pennsylvania.

On the ground

Snow on the ground in Southern California.
Snow blowing from a roof in Ottawa, Ontario, Canada
Snowfall in San Bernardino, California , United States
Artificial snow
Snow can be also manufactured using snow cannons, which actually create tiny granules more like soft hail (this is sometimes called "grits" by those in the southern U.S. for its likeness to the texture of the food). In recent years, snow cannons have been produced that create more natural-looking snow, but these machines are prohibitively expensive.[according to whom?]
Blowing snow
Snow on ground that is being moved around by wind. See ground blizzard.
Champagne powder
Very smooth and dry snow, which is good for skiing. The term originates from the ski resorts in the Rocky Mountains, which often have these snow conditions. The Steamboat Ski Resort, in Steamboat Springs, Colorado, holds the trademark[2] for the term Champagne Powder. The name derives from the sparkling wine champagne.
Chopped powder
Powder snow that has been cut up by previous skiers.
Coarse, granular wet snow. Most commonly used by skiers describing good spring snow. Corn is the result of cycles of melting during the day and refreezing at night.
An overhanging formation of windblown snow. Important in skiing and alpine climbing because the overhang can be unstable and hard to see from the windward side.
This covers varieties of snow that all but advanced skiers find impassable. Subtypes are (a) windblown powder with irregularly shaped crust patches and ridges, (b) heavy tracked spring snow re-frozen to leave a deeply rutted surface strewn with loose blocks, (c) a deep layer of heavy snow saturated by rain (although this may go by another term).
A layer of snow on the surface of the snowpack that is stronger than the snow below, which may be powder snow. Depending on their thickness and resulting strength, crusts can be termed "unbreakable", meaning that they will support the weight of a human on skis or "breakable", meaning that they will not. Crusts often result from partial melting of the snow surface by direct sunlight or warm air followed by re-freezing, but can also be created by wind or by surface water.[3]
Depth hoar
Faceted snow crystals, usually poorly or completely unbonded (unsintered) to adjacent crystals, creating a weak zone in the snowpack. Depth hoar forms from metamorphism of the snowpack in response to a large temperature gradient between the warmer ground beneath the snowpack and the surface. The relatively high porosity (percentage of air space), relatively warm temperature (usually near freezing point), and unbonded weak snow in this layer can allow various organisms to live in it.
Finger drift
A narrow snow drift (30 cm to 1 metre in width) crossing a roadway. Several finger drifts in succession resemble the fingers of a hand.
Snow which has been lying for at least a year but which has not yet consolidated into glaciel ice. It is granular.
Heavy crud
See 'Crud'.
Densely packed material formed from snow that doesn't contain air bubbles. Depending on the snow accumulation rate, the air temperature, and the weight of the snow in the upper layers, it can take snow a few hours or a few decades to form into ice.
Packed powder
The most common snow cover on ski slopes, consisting of powder snow that has lain on the ground long enough to become compressed by ski traffic, but is still somewhat soft. This is not "true" powder when referencing snow conditions while performing winter recreation activities (i.e. Snowboarding, Skiing, Tobogganing).
Record 12" fall of packing snow in Dallas, Texas , United States February 2010.
Packing snow
Snow that is at or near the melting point, so that it can easily be packed into snowballs and thrown or used in the construction of a snowman, or a snow fort.
Snow formations of tall upward-pointing blades found at high altitudes.
Pillow drift
A snow drift crossing a roadway and usually 3 to 4.5 metres (10–15 feet) in width and 30 cm to 90 cm (1–3 feet) in depth.
Freshly fallen, uncompacted snow. The density and moisture content of powder snow can vary widely; snowfall in coastal regions and areas with higher humidity is usually heavier than a similar depth of snowfall in an arid or continental region. Light, dry (low moisture content, typically 4–7% water content) powder snow is prized by skiers and snowboarders. It is often found in the Rocky Mountains of North America and in most regions in Japan.
The textures of a snowdrift on the Long Mynd, Shropshire
Snow which partially melts upon reaching the ground, to the point that it accumulates in puddles of partially frozen water.
Snow covered with dirt, which occurs most often in spring, in Prairie States like North Dakota, where strong winds pick up black topsoil from uncovered farm fields and blow it into nearby towns where the melt rate is slower. The phenomenon is almost magical; one goes to sleep with white snow outside and awakens to black snow. Also, snow that is dirty, often seen by the side of roads and parking lots near areas that have been plowed.
Large piles of snow which occur near walls and curbs, as the wind tends to push the snow up toward the vertical surfaces.
Surface hoar
Faceted, corn-flake shaped snow crystals that are a type of frost that forms on the surface of the snow pack on cold, clear, calm nights. Subsequent snowfall can bury layers of surface hoar, incorporating them into the snowpack where they can form a weak layer. Sometimes referred to as hoar frost.
Spring snow
Late in the winter season, the mid-morning sun melts the top of the frozen snow base creating a soft layer, 1–2 cm deep, that is ideal for long radius carved turns. This is spring snow. By mid-afternoon, the melted layer is likely to have become too deep for enjoyable skiing, i.e. too heavy or too slushy. On some slopes, the melt layer poses an extreme avalanche risk in the afternoon and ski area management will close such runs by late morning. Ideal spring snow conditions are found when the melt layer does not exceed 2cm and the diurnal cycle of melting and refreezing creates a smooth frozen surface, that does not become overly wet in the sun. An exaggerated melting and refreezing cycle results in 'corn' (see above).
Watermelon snow
A reddish/pink-colored snow, caused by a red-colored green algae called Chlamydomonas nivalis.[4]
Wind slab
A layer of relatively stiff, hard snow formed by deposition of wind blown snow on the leeward side of a ridge or other sheltered area. Wind slabs can form over weaker, softer freshly fallen powder snow, creating an avalanche hazard on steep slopes.
Balls of fine frost formed at low temperatures on the Antarctic plateau during weak wind conditions
Snow surface features sculpted by wind into ridges and grooves

See also


  1. Glossary of Meteorology (2009). "Snow". American Meteorological Society. Archived from the original on 20 February 2009. Retrieved 2009-06-28. 
  2. "Champagne Powder". United States Patent and Trademark Office. Retrieved 2013-12-23. 
  3. "Snow crust - AMS Glossary" (in en). 
  4. William E. Williams; Holly L. Gorton; Thomas C. Vogelmann (January 21, 2003). "Surface gas-exchange processes of snow algae". Proceedings of the National Academy of Sciences of the United States of America 100 (2): 562–566. doi:10.1073/pnas.0235560100. PMID 12518048. Bibcode2003PNAS..100..562W. 

External links