Board foot

From HandWiki
Short description: Unit of measurement
board foot
Unit ofVolume
SymbolFBM 
Conversions
1 FBM in ...... is equal to ...
   SI base units   ≈0.002359737 m3
   US Customary   112 ft3

The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada . It equals the volume of a one-foot (305 mm) length of a board, one foot wide and one inch (25.4 mm) thick.

Board foot can be abbreviated as FBM (for "foot, board measure"), BDFT, or BF. A thousand board feet can be abbreviated as MFBM, MBFT, or MBF. Similarly, a million board feet can be abbreviated as MMFBM, MMBFT, or MMBF.

Until the 1970s, in Australia and New Zealand, the terms super foot and superficial foot were used with the same meaning.[1][2][3]

Description

One board foot equals:

Usage

A common two by four board

The board foot is used to measure rough lumber (before drying and planing with no adjustments) or planed/surfaced lumber. An example of planed lumber is softwood "two by four" lumber sold by large lumber retailers, nominally 2 by 4 inches (50 mm × 100 mm). The 2 × 4 is actually only 1 12 in × 3 12 in (38 mm × 89 mm), but the dimensions for the lumber when purchased wholesale could still be represented as full 2 × 4 lumber, although the "standard" can vary between vendors. This means that nominal lumber includes air space around the physical board when calculating board feet in some situations, while the true measurement of "board feet" should be limited to the actual dimensions of the board.

For planed lumber, board feet refer to the nominal thickness and width of lumber, calculated in principle on its size before drying and planing. Here, the actual length is used.

Note: see dimensional lumber for a full discussion of the relationship of actual and nominal dimensions. Briefly, for softwoods, to convert nominal to actual, subtract 14 inch (6 mm) for dimensions under 2 inches; subtract 12 inch (13 mm) for dimensions over 2 inches and under 8 inches; and subtract 34 inch (19 mm) for larger measurements. The system is more complicated for hardwoods.

See also


References