Physics:Submarine depth ratings
This article needs additional citations for verification. (November 2020) (Learn how and when to remove this template message) |
Depth ratings are primary design parameters and measures of a submarine's ability to operate underwater. The depths to which submarines can dive are limited by the strengths of their hulls.
Ratings
The hull of a submarine must be able to withstand the forces created by the outside water pressure being greater than the inside air pressure. The outside water pressure increases with depth and so the stresses on the hull also increase with depth. Each 10 metres (33 feet) of depth puts another atmosphere (1 bar, 14.7 psi, 101 kPa) of pressure on the hull, so at 300 metres (1,000 feet), the hull is withstanding thirty atmospheres (30 bar, 441 psi, 3,000 kPa) of water pressure.
Test depth
This is the maximum depth at which a submarine is permitted to operate under normal peacetime circumstances, and is tested during sea trials. The test depth is set at two-thirds (0.66) of the design depth for United States Navy submarines, while the Royal Navy sets test depth at 4/7 (0.57) the design depth, and the German Navy sets it at exactly one-half (0.50) of design depth.[1]
Operating depth
Also known as the maximum operating depth (or the never-exceed depth), this is the maximum depth at which a submarine is allowed to operate under any (e.g. battle) conditions.
Design depth
The nominal depth listed in the submarine's specifications. From it the designers calculate the thickness of the hull metal, the boat's displacement, and many other related factors.
Crush depth
Sometimes referred to as the "collapse depth" in the United States,[2] [citation needed] this is the submerged depth at which the submarine implodes due to water pressure. Technically speaking, the crush depth should be the same as the design depth, but in practice is usually somewhat deeper. This is the result of compounding safety margins throughout the production chain, where at each point an effort is made to at least slightly exceed the required specifications to account for imperceptible material defects or variations in machining tolerances.
A submarine, by definition, cannot exceed crush depth without being crushed. However, when a prediction is made as to what a submarine's crush depth might be, that prediction may subsequently be mistaken for the actual crush depth of the submarine. Such misunderstandings, compounded by errors in translation and a more general confusion as to the meanings of the various depth ratings, have resulted in multiple erroneous accounts of submarines not being crushed at their crush depth.
Notably, several World War II submarines reported that, due to flooding or mechanical failure, they'd gone below crush depth, before successfully resurfacing after having the failure repaired or the water pumped out. In these cases, the "crush depth" is invariably either a mistranslated official "safe" depth (i.e. the test depth, or the maximum operating depth), or the design depth, or a prior—and evidently incorrect—estimate of what the crush depth might be. World War II German U-boats of the types VII and IX generally imploded at depths of 200 to 280 metres (660 to 920 feet).[citation needed]
See also
- HY-80 steel
- USS Thresher (SSN-593) – a submarine that likely imploded after reaching its crush depth
References
- ↑ Federation of American Scientists (8 December 1998). "Run Silent, Run Deep". Military Analysis Network. http://www.fas.org/man/dod-101/sys/ship/deep.htm.
- ↑ "Joint Publication 1-02: Dictionary of Military and Associated Terms". Department of Defense. 19 August 2009. http://www.fas.org/irp/doddir/dod/jp1_02.pdf.
![]() | Original source: https://en.wikipedia.org/wiki/Submarine depth ratings.
Read more |