Dynamic Multipoint Virtual Private Network

From HandWiki

Dynamic Multipoint Virtual Private Network (DMVPN)[1] is a dynamic tunneling form of a virtual private network (VPN) supported on Cisco IOS-based routers, and Huawei AR G3 routers,[2] and on Unix-like operating systems.

Process

DMVPN provides the capability for creating a dynamic-mesh VPN network without having to pre-configure (static) all possible tunnel end-point peers, including IPsec (Internet Protocol Security) and ISAKMP (Internet Security Association and Key Management Protocol) peers.[3] DMVPN is initially configured to build out a hub-and-spoke network by statically configuring the hubs (VPN headends) on the spokes, no change in the configuration on the hub is required to accept new spokes. Using this initial hub-and-spoke network, tunnels between spokes can be dynamically built on demand (dynamic-mesh) without additional configuration on the hubs or spokes.[citation needed] This dynamic-mesh capability alleviates the need for any load on the hub to route data between the spoke networks.

Technologies

  • Next Hop Resolution Protocol, RFC 2332
  • Generic Routing Encapsulation (GRE), RFC 1701, or multipoint GRE if spoke-to-spoke tunnels are desired
  • An IP-based routing protocol, EIGRP, OSPF, RIPv2, BGP or ODR (DMVPN hub-and-spoke only).[4]
  • IPsec (Internet Protocol Security) using an IPsec profile, which is associated with a virtual tunnel interface in IOS software. All traffic sent via the tunnel is encrypted per the policy configured (IPsec transform set)

Internal routing

Routing protocols such as OSPF, EIGRP v1 or v2 or BGP are generally run between the hub and spoke to allow for growth and scalability. Both EIGRP and BGP allow a higher number of supported spokes per hub.[5]

Encryption

As with GRE tunnels, DMVPN allows for several encryption schemes (including none) for the encryption of data traversing the tunnels. For security reasons Cisco recommend that customers use AES.[6]

Phases

DMVPN has three phases that route data differently.

  • Phase 1: All traffic flows from spokes to and through the hub.
  • Phase 2: Start with Phase 1 then allows spoke-to-spoke tunnels based on demand and triggers.
  • Phase 3: Starts with Phase 1 and improves scalability of and has fewer restrictions than Phase 2.

References

  1. ↑ Cisco engineers. "Dynamic Multipoint IPsec VPNs (Using Multipoint GRE/NHRP to Scale IPsec VPNs)" (in en). Cisco. https://www.cisco.com/c/en/us/support/docs/security-vpn/ipsec-negotiation-ike-protocols/41940-dmvpn.html. Retrieved 24 September 2017. 
  2. ↑ Huawei DSVPN Configuration
  3. ↑ Kurniadi, S. H.; Utami, E.; Wibowo, F. W. (Dec 2018). "Building Dynamic Mesh VPN Network using MikroTik Router" (in en). Journal of Physics: Conference Series 1140: 012039. doi:10.1088/1742-6596/1140/1/012039. ISSN 1742-6596. 
  4. ↑ DMVPN Design Guide: Using a Routing Protocol Across the VPN
  5. ↑ DMVPN Design Guide: Routing Protocol Configuration
  6. ↑ DMVPN Design Guide: Best Practices and Known Limitations

External links



Retrieved from "https://handwiki.org/wiki/index.php?title=Dynamic_Multipoint_Virtual_Private_Network&oldid=3363861"