Chemistry:Sodium ethoxide
| |
| |
| Names | |
|---|---|
| Other names
Sodium ethanolate, sodium ethylate (obsolete)
| |
| Identifiers | |
3D model (JSmol)
|
|
| 3593646 | |
| ChEBI | |
| ChemSpider | |
| EC Number |
|
PubChem CID
|
|
| UNII | |
CompTox Dashboard (EPA)
|
|
| |
| |
| Properties | |
| CH 3CH 2ONa | |
| Molar mass | 68.051 g·mol−1 |
| Appearance | White hygroscopic powder |
| Density | 0.868 g/cm3 (of a 21 wt% solution in ethanol) |
| Melting point | 260 °C (500 °F; 533 K) |
| Reacts | |
| Solubility | ethanol and methanol |
| Acidity (pKa) | 15.5[1] |
| Hazards | |
| Safety data sheet | Oxford MSDS |
| GHS pictograms |   
|
| GHS Signal word | Danger |
| H228, H251, H302, H314 | |
| P210, P235+410, P240, P241, P260, P264, P270, P280, P301+312, P301+330+331, P303+361+353, P304+340, P305+351+338, P310, P321, P330, P363, P370+378, P405, P407, P413, P420, P501 | |
| NFPA 704 (fire diamond) | |
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa). | |
 verify (what is   ?)
| |
| Infobox references | |
Sodium ethoxide, also referred to as sodium ethanolate, is the ionic, organic compound with the formula CH
3CH
2ONa, C
2H
5ONa, or NaOEt (Et = ethyl). It is a white solid, although impure samples appear yellow or brown. It dissolves in polar solvents such as ethanol. It is commonly used as a strong base.[2]
Preparation
Few procedures have been reported to prepare the anhydrous solid. Instead the material is typically prepared in a solution with ethanol. It is commercially available and as a solution in ethanol. It is easily prepared in the laboratory by treating sodium metal with absolute ethanol:[3]
- 2 CH
3CH
2OH + 2 Na → 2 CH
3CH
2ONa + H
2
The reaction of sodium hydroxide with anhydrous ethanol suffers from incomplete conversion to the ethoxide.
Structure
The crystal structure of sodium ethoxide has been determined by X-ray crystallography. It consists of layers of alternating Na+
and O−
centres with disordered ethyl groups covering the top and bottom of each layer. The ethyl layers pack back-to-back resulting in a lamellar structure. The reaction of sodium and ethanol sometimes forms other products such as the disolvate CH
3CH
2ONa · 2CH
3CH
2OH. Its crystal structure has been determined, although the structure of other phases in the CH
3CH
2ONa/CH
3CH
2OH system remain unknown.[4]
 |
150px | 
|
| ball-and-stick model of layer stacking in the crystal structure of CH 3CH 2ONa |
coordination geometry at Na | coordination geometry at O |
Reactions
Sodium ethoxide is commonly used as a base in the Claisen condensation[5] and malonic ester synthesis.[6] Sodium ethoxide may either deprotonate the α-position of an ester molecule, forming an enolate, or the ester molecule may undergo a nucleophilic substitution called transesterification. If the starting material is an ethyl ester, trans-esterification is irrelevant since the product is identical to the starting material. In practice, the alcohol/alkoxide solvating mixture must match the alkoxy components of the reacting esters to minimize the number of different products.
Many alkoxides are prepared by salt metathesis from sodium ethoxide.
Stability
Sodium ethoxide is prone to reaction with both water and carbon dioxide in the air.[7] This leads to degradation of stored samples over time, even in solid form. The physical appearance of degraded samples may not be obvious, but samples of sodium ethoxide gradually turn dark on storage. It has been reported that even newly-obtained commercial batches of sodium ethoxide show variable levels of degradation, and responsible as a major source of irreproducibility when used in Suzuki reactions.[7]
New bottle of sodium ethoxide from Sigma-Aldrich
Freshly opened container of sodium ethoxide showing discoloration caused by degradation when stored over oxygen and carbon dioxide.
In moist air, CH
3CH
2ONa hydrolyses rapidly to sodium hydroxide (NaOH). The conversion is not obvious and typical samples of CH
3CH
2ONa are contaminated with NaOH.
In moisture-free air, solid sodium ethoxide can form sodium ethyl carbonate from fixation of carbon dioxide from the air. Further reactions lead to degradation into a variety of other sodium salts and diethyl ether.[7]
This instability can be prevented by storing sodium ethoxide under an inert atmosphere (e.g., N
2).
Safety
Sodium ethoxide is a strong base, and is therefore corrosive.
See also
References
- ↑ disassociation constant of ethanol, referenced in the CRC Handbook of Chemistry and Physics 87th edition.
- ↑ K. Sinclair Whitaker; D. Todd Whitaker (2001). "Sodium Ethoxide". in Charette, André B.. Encyclopedia of Reagents for Organic Synthesis. John Wiley & Sons. doi:10.1002/047084289X.rs070. ISBN 978-0-470-84289-8.
- ↑ C. S. Marvel, E. E. Dreger (1926). "Ethyl Acetopyruvate". Organic Syntheses 6: 40. doi:10.15227/orgsyn.006.0040.
- ↑ M. Beske; L. Tapmeyer; M. U. Schmidt (2020). "Crystal structure of sodium ethoxide (C2H5ONa), unravelled after 180 years". Chem. Commun. 56 (24): 3520–3523. doi:10.1039/C9CC08907A. PMID 32101200.
- ↑ Clayden, Jonathan; Greeves, Nick; Warren, Stuart (2012). Organic chemistry (2nd ed.). New York: Oxford University Press. p. 645. ISBN 978-0-19-927029-3.
- ↑ Wang, Zerong (15 September 2010). Comprehensive organic name reactions and reagents. John Wiley. pp. 1811–1815. ISBN 978-0-471-70450-8.
- ↑ 7.0 7.1 7.2 Wethman, Robert; Derosa, Joseph; Tran, Van; Kang, Taeho; Apolinar, Omar; Abraham, Anuji; Kleinmans, Roman; Wisniewski, Steven et al. (2020-08-19), An Under-Appreciated Source of Reproducibility Issues in Cross-Coupling: Solid-State Decomposition of Primary Sodium Alkoxides in Air, American Chemical Society (ACS), doi:10.26434/chemrxiv.12818234.v1, https://figshare.com/articles/preprint/An_Under-Appreciated_Source_of_Reproducibility_Issues_in_Cross-Coupling_Solid-State_Decomposition_of_Primary_Sodium_Alkoxides_in_Air/12818234
 |  |
