Engineering:Transaxle

From HandWiki
Short description: Combined transmission, axle and differential in one assembly.
Csonka transaxle from 1908
Drawing of the "Alfa Transaxle" layout, with gearbox mounted in block at the rear differential; also inboard brakes to reduce unsprung mass

A transaxle is a single mechanical device which combines the functions of an automobile's transmission, axle, and differential into one integrated assembly.[1] It can be produced in both manual and automatic versions.

Engine and drive at the same end

Transaxles are nearly universal in all automobile configurations that have the engine placed at the same end of the car as the driven wheels: the front-engine/front-wheel-drive; rear-engine/rear-wheel-drive; and mid-engine/rear-wheel-drive arrangements.

Many mid- and rear-engined vehicles use a transverse engine and transaxle, similar to a front-wheel-drive unit. Others use a longitudinal engine and transaxle like Ferrari's 1989 Mondial t which used a "T" arrangement with a longitudinal engine connected to a transverse transaxle. Front-wheel-drive versions of modern Audis, from the A4 upwards, along with their related marques from the Volkswagen Group (which share the same automobile layout) also use a similar layout, but with the transaxle also mounted longitudinally.

The front-wheel-drive Renault 16 had a longitudinal engine and transaxle, with the engine behind the transaxle. The transaxle case was designed to allow the final-drive ring gear to be on either side of the pinion; this allowed the engine-transaxle assembly to be used in the rear-wheel-drive Lotus Europa, which had the engine in front of the transaxle (i.e., mid-engined).

Front-engine, rear-wheel-drive transaxles

Front-engine, rear-wheel-drive vehicles tend to have the transmission up front just after the engine, but sometimes a front-engine drives a rear-mounted transaxle. This is generally done for reasons of weight distribution and is therefore common on sports cars. Another advantage is that since the driveshaft spins at engine speed, it only has to endure the torque of the engine instead of the torque multiplied by the 1st gear ratio. This design was pioneered in the 1934 Škoda Popular, and then in the 1950 Lancia Aurelia, designed by Vittorio Jano.

Since this placement of the gearbox is unsuitable for a live axle (due to excessive unsprung mass), the rear suspension is either independent, or uses a de Dion tube (notably in Alfa Romeos). Rare exceptions to this rule were the Bugatti T46 and T50 which had a three speed gearbox on a live axle.

Notable front-engine, rear-wheel-drive vehicles with a transaxle design include:


Note: The C5, C6 and C7 Corvettes, produced in the 1997 to 2019 model years, do not feature an integrated transaxle, where the transmission, axle and differential are combined into a single assembly. These years actually featured a rear-mounted transmission, which was a stand-alone unit bolted directly to the differential. While many, including General Motors, refer to this configuration as a transaxle, the first Corvette with an integrated transaxle was produced in the eighth generation Corvette, which was released in the 2020 model year.

Rear-engine, rear-wheel-drive transaxles

Volkswagen and later Porsche made extensive use of transaxles in their rear (and mid) engined vehicles. Over the years, models adopting this configuration have included:


Four-wheel-drive

All Audi cars with longitudinal engines and their 'trademark' quattro four-wheel-drive (4WD) system, along with their related marques from the Volkswagen Group which share the same layout, utilise a transaxle. This is mounted immediately behind the front-mounted engine (again, longitudinally) and contains the 'gearbox' (manual, automatic, DSG, or CVT), along with both the centre differential, and the front differential and final drive unit.

The Nissan GT-R and Ferrari FF (and its successors) are unusual in being all-wheel-drive cars with front-engined layouts and rear-mounted transaxles. In the Nissan, one driveshaft sends power to the transaxle (which also contains the 'center' differential) and another driveshaft sends power back along the car to the front wheels. In the Ferrari, the rear transaxle works in a conventional manner, whilst the drive to the front wheels comes from a separate gearbox at the front of the engine.

Other 4WD applications include:

See also

References