Chemistry:Silver fulminate

From HandWiki
Revision as of 01:06, 6 February 2024 by OrgMain (talk | contribs) (linkage)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Short description: High explosive used in bang snaps
Silver fulminate
Silver fulminate.svg
Names
IUPAC names
Silver carbidooxidonitrate(1−)[1]
Silver oxidoazaniumylidynemethane[2]
Other names
Silver fulminate
Silver(I) fulminate
Argentous fulminate
Identifiers
3D model (JSmol)
ChemSpider
UNII
Properties
AgCNO
Molar mass 149.885 g/mol
Density 3.938 g/cm3
Explosive data
Shock sensitivity Extremely high
Friction sensitivity Extremely high
Hazards
Main hazards Sensitive high explosive
NFPA 704 (fire diamond)
Flammability code 3: Liquids and solids that can be ignited under almost all ambient temperature conditions. Flash point between 23 and 38 °C (73 and 100 °F). E.g. gasolineHealth code 3: Short exposure could cause serious temporary or residual injury. E.g. chlorine gasReactivity code 4: Readily capable of detonation or explosive decomposition at normal temperatures and pressures. E.g. nitroglycerinSpecial hazards (white): no codeNFPA 704 four-colored diamond
3
3
4
170 °C (338 °F; 443 K)
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
☑Y verify (what is ☑Y☒N ?)
Infobox references

Silver fulminate (AgCNO) is the highly explosive silver salt of fulminic acid.

Silver fulminate is a primary explosive, but has limited use as such due to its extreme sensitivity to impact, heat, pressure, and electricity. The compound becomes progressively sensitive as it is aggregated, even in small amounts; the touch of a falling feather, the impact of a single water droplet, or a small static discharge are all capable of explosively detonating an unconfined pile of silver fulminate no larger than a dime and no heavier than a few milligrams. Aggregating larger quantities is impossible, due to the compound's tendency to self-detonate under its own weight.

Silver fulminate was first prepared in 1800 by Edward Charles Howard in his research project to prepare a large variety of fulminates. Along with mercury fulminate, it is the only fulminate stable enough for commercial use. Detonators using silver fulminate were used to initiate picric acid in 1885, but since have been used only by the Italian Navy.[3] The current commercial use has been in producing non-damaging novelty noisemakers as children's toys.

Structure

Ball-and-stick model of the cyclic hexamer in trigonal silver fulminate

Silver fulminate occurs in two polymorphic forms, an orthorhombic one and a trigonal one with a rhombohedral lattice.[4] The trigonal polymorph consists of cyclic hexamers, (AgCNO)6.[5]

Needles of silver fulminate

Properties

Fulminates are toxic, about the same as cyanides.[3] When pure, silver fulminate is chemically stable, not decomposing after years of storage. Like many silver salts, it darkens with light exposure. It is slightly soluble in cold water and can be recrystallized using hot water.[3][6] It can also be recrystallized from a 20% solution of ammonium acetate.[3] It is not hygroscopic and can explode when moist or under water; it was reported to remain explosive after 37 years under water.[3] It explodes upon contact with concentrated sulfuric acid or chlorine or bromine, but not when contacting iodine.[3] It is insoluble in nitric acid, but dissolves in ammonia, alkali chlorides, alkali cyanides, aniline, pyridine, and potassium iodide by forming complexes.[3] Concentrated hydrochloric acid decomposes it non-explosively with a hissing noise; thiosulfate also decomposes it non-explosively, and can be used for disposal.[3]

Preparation

This compound can be prepared by pouring a solution of silver nitrate in nitric acid into ethanol, under careful control of the reaction conditions, to avoid an explosion.[7] The reaction is usually done at 80–90 °C; at 30 °C, the precipitate may not form.[3] Only tiny amounts of silver fulminate should be prepared at once, as even the weight of the crystals can cause them to self-detonate. Another way to make silver fulminate is to react silver carbonate with ammonia in solution.[citation needed]

4 Ag2CO3 + 4 NH3 → 4 AgCNO + 6 H2O + 4 Ag + O2

Silver fulminate also forms when nitrogen oxide gas is passed through a solution of silver nitrate in ethanol.[3]

Silver fulminate can be prepared unintentionally, when an acidic solution of silver nitrate comes in contact with alcohol.[7] This is a hazard in some formulations of chemically silvering mirrors.

Novelty explosive

Silver fulminate, often in combination with potassium chlorate, is used in trick noise-makers known as "throw-downs", "crackers", "snappers", "whippersnappers", "pop-its", or "bang snaps", a popular type of novelty firework. They contain approximately 200 milligrams of fine gravel coated with a minute quantity (approximately 80 micrograms)[8] of silver fulminate. When thrown against a hard surface, the impact is sufficient to detonate the tiny quantity of explosive, creating a small salute from the supersonic detonation. Snaps are designed to be incapable of producing damage (even when detonated against skin) due to the buffering effect provided by the much greater mass of the gravel medium. It is also the chemical found in Christmas crackers[9] having first been used for that purpose by Tom Smith in 1860. The chemical is painted on one of two narrow strips of card, with abrasive on the second. When the cracker is pulled, the abrasive detonates the silver fulminate.

A fulminate mixture with 10–20% potassium chlorate is cheaper and more brisant than the fulminate alone.[3]

Silver fulminate and "fulminating silver"

Silver fulminate is often confused with silver nitride, silver azide, or fulminating silver. "Fulminating silver", though always referring to an explosive silver-containing substance, is an ambiguous term. While it may be a synonym of silver fulminate, it may also refer to the nitride or azide, the decomposition product of Tollen's reagent, or an alchemical mixture, which does not contain the fulminate anion.

See also

References

  1. International Union of Pure and Applied Chemistry (2005). Nomenclature of Inorganic Chemistry (IUPAC Recommendations 2005). Cambridge (UK): RSCIUPAC. ISBN:0-85404-438-8. p. 291. Electronic version.
  2. "Silver fulminate". ChemBase. http://www.chembase.com/cbid_62585.htm. Retrieved 8 June 2012. [yes|permanent dead link|dead link}}]
  3. 3.00 3.01 3.02 3.03 3.04 3.05 3.06 3.07 3.08 3.09 3.10 Matyas, Robert; Pachman, Jiri (Mar 12, 2013). Primary Explosives. Springer Science & Business Media, 338 pages. 
  4. Britton, D.; Dunitz, J. D. (1965). "The Crystal Structure of Silver Fulminate". Acta Crystallographica 19 (4): 662–668. doi:10.1107/S0365110X6500405X. Bibcode1965AcCry..19..662B. 
  5. Britton, D. (1991). "A Redetermination of the Trigonal Silver Fulminate Structure". Acta Crystallographica C 47 (12): 2646–2647. doi:10.1107/S0108270191008855. Bibcode1991AcCrC..47.2646B. 
  6. 0.0075 gm at 13 °C, 0.018 gm at 30 °C, and 0.25 gm per 100 gm H2O at 100 °C
  7. 7.0 7.1 Collins, P. H.; Holloway, K. J. (1978). "A Reappraisal of silver fulminate as a detonant". Propellants, Explosives, Pyrotechnics 3 (6): 159–162. doi:10.1002/prep.19780030603. 
  8. package disclosure of Alexron Co. Ltd, Hong Kong, Phantom Brand Bang Snaps, (c)2013
  9. Spectrum. "Comment #70". Old Firework Factory Locations. UK Pyrotechnics Society. http://www.pyrosociety.org.uk/forum/topic/4101-old-firework-factory-locations/page__st__60. Retrieved 20 December 2011. 

Further reading